Room images are indicative
Shipping 6–8 working days
Wallpaper
·Contemporary abstract ·SKU: GIA-10951223-wallpaper
Koala's Gum Tree by:Anna AntoniniGetinArt artist
–
Enter measurements to calculate
Price per m²
48,45 €39,71 € + VAT
1
Choose the textureselected -
2
Wall measurementsEntered
cm
cm
Minimum size 100×100 cm, maximum 500×500 cm.
3
![]()
Position the graphicConfirmed
Enter the measurements (step 2) to unlock
Graphic centred
Koala's Gum Tree nasce dall'amore per i Koala , animali in grave via d'estinzione, specie unica dell'Australia ,paese dove sono nata e vissuta.Qui sono rappresentati attraverso il legame con l'eucalipto, fonte di nutrimento e rifugio per loro. Due Koala emergono tra foglie e forme decorative, in un intreccio di gialli dorati, aranci.verdi e delicati azzurri. Pennellate spontanee, e forme circolari evocano il calore della natura circostante e un senso di quiete e protezione rifiniscono la pittura.
Product details
LineaWallpaper
ArtistAnna Antonini
CategoriaContemporary abstract
StampaSu misura al centimetro, inchiostri certificati
01
Prepare the wall
The wall must be clean, dry, smooth and free of dust, grease or old glue residue. On new or very absorbent plaster, apply a coat of primer and let it dry: a uniform base ensures optimal adhesion and colour rendering.
02
Check the panels and layout
Check the panels in good light and lay them out in numbered order. The panels arrive pre-cut with a safety margin on each side, so you can trim precisely once hung and match the pattern perfectly between panels.
03
Mark the plumb line
From the first corner, measure the panel width and draw a vertical reference line with a level (or a plumb line). Starting perfectly level is the step that keeps all the following panels straight and aligned.
04
Apply the glue or wet the panel
For traditional substrates, spread non-woven wallpaper paste directly on the wall, one section at a time, without excess at the edges. If you chose a pre-pasted substrate, no glue is needed: simply dampen the back of the panel (or the wall) with a damp sponge and wait a few moments for the adhesive to activate.
05
Hang it and match the pattern
Position the panel along the marked line, leaving a few centimetres of excess at the top and bottom. Match the pattern with the previous panel, then smooth from the centre outwards with the soft spatula to remove air bubbles and creases.
06
Trim and clean
With a sharp blade and a spatula as a guide, trim the excess along skirting boards, ceiling and corners. Immediately remove any glue residue with a clean, damp sponge before it dries. Let the wall dry without direct draughts.
