Questa pagina è disponibile anche in italiano. Passa all'italiano
Free shipping over 250 € · Use code BENVENUTO10 for –10% on your first order
Custom prints Popular New Inspiration
Language
IT EN
Wallpaper ·Animals ·SKU: GIA-495684

Polar Bear With Cubs

Mother polar bear with her two curious cubs on snow

Enter measurements to calculate
Price per m²
42,00 €/m²
1
Choose the textureselected -
2
Wall measurementsEntered
cm
cm
Minimum size 100×100 cm, maximum 500×500 cm.
3
Position the graphicConfirmed
Enter the measurements (step 2) to unlock
Graphic centred

A captivating black and white photograph showcases a mother polar bear seated gracefully on the snow, flanked by her two small cubs. The animals dominate the frame, with the adult bear providing a sense of protection while her cubs display a curious vulnerability. This simple yet compelling composition focuses on the intimate family moment, highlighting the textures of their fur and their expressive gazes within the expansive

LineaWallpaper
CategoriaAnimals
StampaSu misura al centimetro, inchiostri certificati
01
Prepare the wall
The wall must be clean, dry, smooth and free of dust, grease or old glue residue. On new or very absorbent plaster, apply a coat of primer and let it dry: a uniform base ensures optimal adhesion and colour rendering.
02
Check the panels and layout
Check the panels in good light and lay them out in numbered order. The panels arrive pre-cut with a safety margin on each side, so you can trim precisely once hung and match the pattern perfectly between panels.
03
Mark the plumb line
From the first corner, measure the panel width and draw a vertical reference line with a level (or a plumb line). Starting perfectly level is the step that keeps all the following panels straight and aligned.
04
Apply the glue or wet the panel
For traditional substrates, spread non-woven wallpaper paste directly on the wall, one section at a time, without excess at the edges. If you chose a pre-pasted substrate, no glue is needed: simply dampen the back of the panel (or the wall) with a damp sponge and wait a few moments for the adhesive to activate.
05
Hang it and match the pattern
Position the panel along the marked line, leaving a few centimetres of excess at the top and bottom. Match the pattern with the previous panel, then smooth from the centre outwards with the soft spatula to remove air bubbles and creases.
06
Trim and clean
With a sharp blade and a spatula as a guide, trim the excess along skirting boards, ceiling and corners. Immediately remove any glue residue with a clean, damp sponge before it dries. Let the wall dry without direct draughts.